Automatic lathe position Environmental requirements: the position of the machine tool should be far from the vibration source, should avoid the influence of direct sunlight and thermal radiation, to avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, the anti-vibration ditch should be set up around the machine tool. Otherwise, it will directly affect the processing accuracy and stability of the automatic lathe, which will make the electronic components in poor contact, failure, and affect the reliability of the machine tool.

Temperature conditions: the ambient temperature of the automatic lathe is less than 30 degrees, and the relative temperature is less than 80%. In general, the CNC electric control box is equipped with an exhaust fan or chiller to keep the electronic components, especially the central processor, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity will lead to reduced life of the control system components and lead to increased failure. The increase in temperature and humidity, the increase in dust will produce a bond in the integrated circuit board, and lead to short circuit.

Power requirements: General automatic lathes are installed in the machining workshop, not only the ambient temperature changes, the use of poor conditions, and a variety of mechanical and electrical equipment, resulting in large fluctuations in the power grid. Therefore, the position of the CNC lathe installation requires strict control of the power supply voltage. Power supply voltage fluctuations must be within the allowable range and remain relatively stable. Otherwise, it will affect the normal work of the numerical control system.

Standard use of machine tools: When using machine tools, users are not allowed to change the parameters set by the manufacturer in the control system at will. The setting of these parameters is directly related to the dynamic characteristics of each machine tool component. Only the value of the gap compensation parameter can be adjusted according to the actual situation.

Do not replace machine accessories at will, such as the use of hydraulic chuck beyond the specifications. CNC lathe customization manufacturers fully consider the matching of parameters of each link when setting accessories. Blind replacement causes the mismatch of the parameters of each link, and even causes unexpected accidents. The pressure of using hydraulic chuck, hydraulic tool holder, hydraulic tailstock and hydraulic cylinder should be within the allowable stress range and not allowed to be increased arbitrarily.

automatic transfer machine https://www.zjshuangzheng.com/Integrated-Transfer-Machine.html